Heat stress and cooling systems for dairy cows

Carbohydrates - Keeping Diets Simple While Keeping Production High

Carbohydrate is the most important source of energy for rumen microorganisms and the single largest component (65-75%) of a dairy cow’s diet. The use of carbohydrates by rumen microorganisms is critical in maximizing microbial protein yield and still maintaining rumen function. C a r b o h y d r a t e s represent the major component of net energy for support of maintenance and milk production. Dairy cattle have a requirement for fibrous feedstuffs in the diet. Defining these requirements for balancing rations requires knowledge of many interacting components within the diet as well as how the feed is allocated and processed. In order for high producing dairy cattle to meet their high energy demands, diets must consist of adequate quantities of concentrates and high quality forages containing relatively low amounts of fiber. However, to maintain normal rumen function and milk fat percentage a large portion of the fiber needs to come from forage

This is especially critical during the summer months when cows experience heat stress and high humidity which can occur during many of the months in the summer in Pennsylvania (see figure below).

DF-HeatStressChartDairy cows may reduce their feed intake during hot weather. Typically, early lactation cows are most severely affected. Forage generates more heat than a grain ration, thereby contributing to reduced intake. One way to correct this problem is to feed high quality forage during the summer, thus requiring less intake to maintain a balanced ration. Never, however, reduce the fiber level below 18 to 19 percent ADF and 25 to 28 percent NDF. If cows reduce their intake during heat stress, more nutrients need to be packed into a smaller volume of feed. Remember that a cow’s energy requirement for lactation is unchanged and her energy needs to remain cool actually increase. Therefore, maintaining adequate nutrient intake becomes critical to avoid undue milk production loss.

One option to assure adequate fiber intake but not increase the heat load is to use nonforage fiber sources. Various nonforage fiber sources such as soybean hulls, beet pulp, corn gluten feed, cotton seed hulls, whole linted cottonseed, dried distillers grains, and wheat middlings have been used in the diets of lactating cows to supplement conventional forage fiber. Many of these contain more NDF than some forage sources. One of the major differences between nonforage and forage sources of NDF is particle size. Although differences exist among feedstuffs, nonforage fiber is less effective at maintaining good chewing activity and ruminal health compared with forage fiber of adequate particle size. Therefore when forage NDF is replaced by nonforage NDF it is on the average 50% as effective in stimulating chewing activity and/or milk fat percent as that of forage NDF. The only exceptions are cotton seed hulls and corn cobs which have similar effectiveness to hay. When replacing forage with these by-products rations should be formulated for a higher total NDF level.

When feeding dairy cows adequate pounds of NDF and forage NDF are critical especially for early lactation cows (see table for requirements). One of the most common causes of acidosis occurs when diets are too low in effective fiber or too small particle size. When animals don’t chew their cud normally, lack of saliva (that contains a natural buffer) contributes to low rumen pH. In addition, if starch is too high in the diet or too rapidly fermentable this can also contribute to ruminal upsets, cows reducing intake and reduced butterfat.

Common factors leading to acidosis in dairy cattle:

  • Diet too high in fermentable carbohydrates; starch (% ration DM) > 28%
  • Concentrate:forage ratio >55%
  • Too fast a switch from high forage to high concentrate
  • Too fast a switch from silage to high levels of green chop forage
  • Low fiber content in diet; < 30% NDF and < 19% forage NDF (% of ration DM)
  • Fecal starch DM > than 4%
  • Diet composed of very wet and highly fermented feeds; >52% moisture
  • Too finely chopped forage; > 5% in bottom pan of PSU particle separator
  • Over mixed TMR resulting in excess particle size reduction; > 20% in pan

Forage diagnostics:

NDF and ADF Total NDF intake

% of BW              1.1 – 1.2%

% of total ration  28-33%

lb per day            13-16

Forage NDF intake

% of BW              0.85 - 1.1%

% of total NDF     >75%

% of ration DM     18-22%

lb per day            11-13

Total ADF intake

lb per day            min 8

 

Source: das.psu.edu
User Comments
Your name * :
E-mail * :
Title * :
Content * (If you can write Vietnamese, Pls use Unicode font):
 
Mã bảo mật * :   
   
Other article